Moon Valley M-1700 Rocker Assembly Instructions

NOTE: Please check contents and read directions carefully before assembly. If any items are missing

or damaged, do not take the product back to the store. Call Moon Valley customer service at

866.332.1616 and we will correct the problem as promptly and as efficiently as possible. Also,

checking or cracking of the logs is a natural part of the drying aspect of cedar. This does not affect the

structural integrity of the wood. This natural occurrence enhances the rustic beauty of the product.

Tools Required: Rubber Mallet or Hammer, ½" Socket & Socket Wrench, Square-Head

Screwdriver

M-1700 Rocker Assembly Instructions

Rocker Components

1. Insert doweled end of single-hole leg piece into double-hole leg piece.

Be sure that both remaining holes are facing the same direction (as

shown). Repeat process with remaining two leg pieces.

2. Attach leg assemblies to dowels on both sides of pre-assembled seat

(as shown). Use rubber mallet to ensure secure fit. If using a hammer,

be sure to pad impact area to prevent damage.

3. Insert doweled ends of pre-assembled seat back into the holes at the rear

of the seat assembly. If doweled ends do not line up, gently tap seat back

sidepieces in or out as needed. Tap top of seat back with rubber mallet or

hammer (with padding) to ensure secure fit (as shown).

(1) Pre-Assembled Seat Back

(1) Pre-Assembled Seat

(2) 9" Braces

(2) Rocker Runners

(4) Leg Pieces (2 single-hole, 2 double-hole)

(6) 3 3/8" Lag Bolts

(4) 2 ½" Square Head Screws

(10) 2" Square Head Screws

Assembly

Table of Contents

Do you have a question about the M-1700 Rocker and is the answer not in the manual?

Page 1 NOTE: Please check contents and read directions carefully before assembly. If any items are missing or damaged, do not take the product back to the store. Call Moon Valley customer service at 866.332.1616 and we will correct the problem as promptly and as efficiently as possible. Also, checking or cracking of the logs is a natural part of the drying aspect of cedar.
Page 2 4. Attach both arm pieces to exposed dowels on the leg assemblies (as shown). At this point, set Rocker on a flat surface to ensure that all components are aligned and the Rocker is level. Use rubber mallet or hammer (with padding) to ensure all dowels are secure in each receiving piece.
Page 3 Attach rocker runners to legs using 3 3/8” lag bolts (as shown in both photos). . Thank you for your Moon Valley purchase and we hope that you enjoy your Rocker. To view other Moon Valley products, please visit us at www.moonvalleyrustic.com.