Mounting The Siren; Mounting The Control Head (Pf200R); Figure 4.3 Bail Bracket Assembly - Federal Signal Corporation Pathfinder Installation And Maintenance Instructions Manual

Mounting the Siren

1. Use the bracket as a template or the dimensions shown in Figure 4.2 to mark the centers of the
two mounting holes.
2. Choose a bit appropriate for the installer-supplied mounting hardware and drill the center of the
two mounting holes.
3. Mount the bracket with the installer-supplied mounting hardware.
4. Insert the ¼-20 carriage bolts into the bracket and loosely install the ¼" washers and Keps nuts.
5. Slide the siren onto the bracket assembly and tighten the ¼" nuts. Do not overtighten.

Mounting the Control Head (PF200R)

The control head comes with two mounting brackets and mounting hardware.
To mount the control head:
1. Secure a bracket to the control head with the 6-32 x ¼ Phillips screws and #6 lock washers
(Figure 4.4 on page 23).
2. Using a 7/16" nut driver, secure the other bracket to the control head/bracket assembly with the
¼-20 x 3/4 hex head screws and ¼" lock washers (Figure 4.5).
3. Use the mounting bracket as a template and scribe two drill position marks at the selected
mounting location.

Figure 4.3 Bail Bracket Assembly

Pathfinder
Chapter 4: Mounting the Pathfinder
TM 23