Figure 4.4 Bracket Attached To Back Of Control Head; Figure 4.5 Brackets Attached To Control Head And Mounting Surface - Federal Signal Corporation Pathfinder Installation And Maintenance Instructions Manual

Chapter 4: Mounting the Pathfinder
4. With an 11/64 bit, drill two mounting holes at the drill position marks.
5. Secure the mounting bracket to the mounting surface with the #10 thread-forming screws
(Figure 5.3).
6. To adjust the angle of the control head, loosen the hinge screws, tilt the control head forward or
backward, then securely tighten the screws
24

Figure 4.4 Bracket Attached to Back of Control Head

Figure 4.5 Brackets Attached to Control Head and Mounting Surface

Pathfinder
TM