Page 2
A copy of this limited warranty can also be obtained by written request to Federal Signal Corporation, 2645 Federal Signal Drive, University Park, IL 60484, email to info@fedsig.com or call +1 708-534-3400.
Contents Safety Messages..............................4 General Description ..............................6 Introduction .................................6 Features ................................6 Customer-Supplied Accessory ........................6 Input/Output Definitions ............................7 Unpacking the Kit ..............................8 Specifications ................................9 Operating Instructions ............................10 Setting up the MAC for use ..........................10 Activating Sirens Using Commander Software ....................11 Powering the MAC ............................11 Testing the MAC ..............................12 Getting Service ..............................12 Figures...
• After installation, service, or maintenance, test the siren system to confirm that it is operating properly. Test the system regularly to confirm that it will be operational in an emergency. Mobile Activation Case (Models MAC-01 and MAC-02)
Page 5
Safety Messages • If future service and operating personnel do not have these instructions to refer to, the siren system may not provide the intended audible warning and service personnel may be exposed to death, permanent hearing loss, or other bodily injury.
The MAC comes in two version: the MAC-01 supports VHF radio networks, and the MAC-02 supports UHF radio networks. The MAC is a portable, self-contained radio transceiver and Modem MSK with power and battery backup.
Input/Output Definitions Input/Output Definitions Figure 1 Front of MAC Radio Case NX-700/NX-800 Radio On/Off switch USB Port BNC Antenna Modem-MSK RS232 port Figure 2 Back of MAC Radio Case 120 VAC charge input 12 Vdc automotive receptacle Figure 3 Backpack Description, Specifications, and Operations Manual...
RS232, DB9(F) to DB9 Cable 1751190A USB Type A/Type B Cable 1751410A MAC Instruction Manual 25500128 Pelican Backpack #S115 864200177 *Included in the Mobile Activation Case enclosure. Figure 4 Picture of MAC Contents Mobile Activation Case (Models MAC-01 and MAC-02)
Charger 14.6 Volt, 1.5 A CC/CV Radio Kenwood NX-700 for MAC-01, supports VHF radio networks Kenwood NX-800 for MAC-02, supports UHF radio networks 30 Watt (Set power per customer specifications and FCC license) Modem MSK Modem radio interface * If you require more radio frequency (RF) coverage, other antenna options are available for purchase.
2. Connect the USB cable between the computer and the USB port located in the front the MAC Radio Case. NOTE: You can use the RS232 port instead of the USB port. Mobile Activation Case (Models MAC-01 and MAC-02)
Operating Instructions Figure 6 USB cable between computer and MAC Radio Case Modem-MSK is on 3. Turn on the power switch located on the front of the MAC Radio Case. Ensure that the radio and Modem-MSK power lights are on. 4.
If you are experiencing any difficulties, contact Federal Signal Customer Care at: 800-548-7229 or 708-534-3400 extension 7511 or Technical Support at: 800-524-3021 or 708-534-3400 extension 7329 or through e-mail at: techsupport@fedsig.com. For instruction manuals and information on related products, visit: http://www.fedsig.com/ Mobile Activation Case (Models MAC-01 and MAC-02)