Data Midi Dump (Receiving) - PROEL MS 32 Owner's Manual

DATA MIDI DUMP (receiving):

If a Data Midi Dump exclusive system is received (the same system generated by the pedalboard
when the Data Midi Dump is transmitting) via Sequencer or Computer, the MS-32 enters the Data
Midi Dump mode and will display the following screen shot:
Receiving Dump.!
alternating with the display of the different memories received.
- The pedalboard memories are thus loaded with the received Midi data, previously saved through
the DATA MIDI DUMP (transmission) procedure.
Note : It is important not to accelerate the DATA DUMP procedure as the pedalboard needs
time to edit the data in the Flash memory.
If there is a reception problem or an error in the data loading, it is advisable to slow
down the dump procedure in the connected computer or sequencer.
- If the pedalboard is switched off during this procedure, incomplete data might be received.
When the data receiving is completed the pedalboard stops on the last memory received or
displays:
Rx Dump Error..!
This means the data reception was not successfully completed; it is necessary to switch the
pedalboard off and activate the Factory Reset functioned described at pages 45/46.
Retry the loading procedure controlling the dump speed and slowing it down if necessary.
48
Proel MS 32 Owner's Manual