Operations; Power On; Change The Set Value (Sv); Change The Alarm Value - Taie FA Series Operation Manual

7. Operations

7.1

Power On

Controller will display as below
All LED and 7 segment
displays will be lighted
7.2

Change the Set Value (SV)

Change SV from 0.0 to 100.0
Press key. The SV
number started to flash.
The flashing digit indicates
which digit can be set.
7.3

Change the Alarm Value

Change AL1 value to "5.0" (AL1 active, if PV exceeds SV over 5.0)
SET
Press key
to display parameter AL1
* The are total 16 alarm mode types, please referred with "alarm mode" in page 30
* To change alarm mode, press
Level) and then change ALD1/ALD2/ALD3 value.
Display input type
(K2)
Press key
to select the hundreds digit.
Press key
to change AL1 value
SET
+
Display range
(0.0~400.0)
Press key
to change the number to 1
Press key
increase AL1 value
key 3 seconds to enter Level 3 (Input
21
Ready for use
SET
Press key
to store the new
set value.
Press SET key
store the new value
of AL1