[Options(2)] - NEC ME342U User Manual

[OPTIONS(2)]

Selecting Power-saving in [STANDBY MODE]
The projector has three standby modes: [NORMAL], [NETWORK STANDBY], and [SLEEP].
The NORMAL mode is the mode that allows you to put the projector in the power-saving condition which consumes
less power than the NETWORK STANDBY mode.
NORMAL ������������������������������� When [NORMAL] is selected, only the following buttons and feature will work:
NETWORK STANDBY �������������� When [NETWORK STANDBY] is selected, the projector can be turned on over a wired LAN connection and
SLEEP ����������������������������������� Maintain the state of sleep� Consumption power becomes higher than the setting of NORMAL� Select this
IMPORTANT:
• When [NETWORK STANDBY] has been set for [STANDBY MODE] and the LAN has been in link-down condition for 3 minutes, [STANDBY
MODE] will transit into [NORMAL] automatically for the purpose to save the consumption power.
• When [NETWORK STANDBY] has been selected, [AUTO POWER OFF] becomes ineffective (displayed in grey) and [0:15] is selected auto-
matically.
• In the below conditions, setting of the [STANDBY MODE] is disabled and the projector will go into the SLEEP mode*.
* S leep mode refers the mode without functional restrictions by the [STANDBY MODE]. Power consumption in the SLEEP mode is relatively
higher than the [NETWORK STANDBY] mode. The Status indicator turns on in Green.
When [STANDBY MODE] → [NETWORK STANDBY] is selected
- When [NETWORK SERVICE] → [AMX SETTINGS] → [ENABLE] is selected
- When [NETWORK SERVICE] → [CRESTRON SETTINGS] → [CRESTRON CONTROL] → [ENABLE] is selected
- W hen [NETWORK SETTINGS] → [WIRELESS LAN] → Except for [DISABLE] and mounting the wireless LAN unit to the projector.
- When the signal is input to the COMPUTER, HDMI 1 IN, HDMI 2 IN or USB-B terminals
NOTE:
• Even when [NORMAL] is selected for [STANDBY MODE], power on or off can be done by using the PC CONTROL port.
• The power consumption in the standby mode will not be included in calculating CO
• Your setting for [STANDBY MODE] will not be affected even when [RESET] is done from the menu.
POWER buttons on the projector cabinet and the remote control, AUTO POWER ON, and powering on from
PC Control command�
only the following buttons, port, and features will work:
POWER buttons on the projector cabinet and the remote control, powering on from PC Control command,
AUTO POWER ON, LAN port, wireless LAN unit (optional), operation by User Supportware, LAN feature,
and Mail Alert feature�
mode in the following cases:
• For using the USB-A port constantly.
emission reduction.
2
71
5. Using On-Screen Menu