NEC Express5800 Series User Manual page 161

Chapter 3 Setup
4. When the Off-line TOOL MENU appears, select BMC Configuration, BMC Configuration, Network,
and then Property.
5. If Property is selected, the following screen is displayed. On this screen, specify whether to use DHCP
and if DHCP is not used, configure IP Address/Subnet Mask.
6. Connect the LAN cable to the management LAN connector in order to connect to the network. It will be
available for use if you access EXPRESSSCOPE Engine 3 via Web browser from PC for management
according to the setting.
If Shared BMC LAN is enabled, Web feature, remote media/KVM feature, or
Tips
command line interface feature may be interrupted. In this case, wait for a while,
and connect with network again.
Express5800/T120g User's Guide
3. EXPRESSSCOPE ENGINE 3
161