NEC Express5800 Series User Manual page 149

Chapter 3 Setup
4. After a while, the following message is displayed on the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
By pressing the designated function key following messages, you can call the functions below upon
completion of POST.
<F2> key:
<F3> key:
<F4> key:
<F12> key: Boot from network.
5. When Legacy is specified for Boot Mode, if a controller which has its dedicated BIOS such as a RAID
Controller is installed, a message that prompts you to start the dedicated utility to configure the card is
displayed.
Example: If an optional RAID Controller is installed
Press <Ctrl> <R> to Run MegaRAID Configuration Utility
The utility starts by pressing the <Ctrl> + <R> keys.
For details on the utility, refer to the manual supplied with each optional board.
Depending on the configuration, the message "Press Any Key" might appear to prompt a key entry. This
is a behavior of the BIOS of the optional board. Continue to operate after checking the manual of the
optional board.
6. If one of the following conditions is met when Secure Boot is set to Enabled in Security menu and
Invalid Signature Detection is set to Halt in BIOS Setup Utility (SETUP), a message will be displayed
saying that invalid signature data was detected:
・The boot image in a bootable device is unsigned
・The signature of the boot image in a bootable device is illegal
In such case, turn off this server and check whether the signature of the boot image in a bootable device
is correct. Connect the device for which Secure Boot is enabled to the server, and then turn on the server
again.
7. The OS starts when POST is completed.
Run BIOS Setup Utility (SETUP). For information on the SETUP, see Chapter 2 (1. System
BIOS) in "Maintenance Guide".
Run EXPRESSBUILDER from Internal Flash Memory (optional). For information on
EXPRESSBUILDER, see Chapter 3 (4. EXPRESSBUILDER).
Note If bootable CD/DVD is inserted into optical disk drive, the system starts from
CD/DVD even if <F3> key is pressed.
Run the offline tool. For information on the offline tool, see Chapter 1 (9. Offline Tools) in
"Maintenance Guide".
Tips
 When no bootable device is connected, the following message is displayed by
terminating POST.
Bootable media is not found.
Press <F2> to enter SETUP.
Press the <F2> key to boot the BIOS setup utility (SETUP).
Express5800/T120g User's Guide
1. Turning on the Server
149