ETC Express 24/48 Quick Manual page 25

encoder assignments refer to the Expression 3 and Insight 3 hardware. On an Express
console, use the navigation keys to move among attributes and pages. When pan or tilt is
selected, the trackpad can be used to control movement.
Setting the intensity directly:
Step 1:
Step 2:
Using Focus Points (see below):
Step 1:
Step 2:
Step 3:
Using encoder settings:
Step 1:
Step 1:
Step 2:
Foc us Points
Focus points are special groups that are used by reference. They are most often used to
set the levels of ML fixtures. Levels that reference a focus point automatically update if the
corresponding levels in the focus point change.
Record a Focus Point:
Step 1:
Step 2:
Step 3:
Step 4:
Working with Moving Light (ML) Fixtures
Select fixtures using the procedure described in
Press [At] [x], where [x] is the intensity level. You can also use the [Full] and
[Level] keys.
Select fixtures using the procedure described in
Select an attribute or attribute category using the procedures
Attribute, page 20 or Select Attributes by Category, page
Press [At] [Focus Point] [#] [Enter].
Select fixtures using the procedure described in
Select an attribute or attribute category using the procedures
Attribute, page 20 or Select Attributes by Category, page
Use the arrow keys and trackpad to set attribute levels.
Press [Stage] to enter the Stage display.
Select channels using the procedure
Set levels for those channels using the procedure
Press [Record] [Focus Point] [#] [Enter].
Select ML Fixtures, page
Select ML Fixtures, page
20.
Select ML Fixtures, page
20.
Select channels:, page
Set Channel Levels, page
20.
20.
Select a Fixture
20.
Select a Fixture
8.
8.
21