Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Crane Manuals
  4. Water Pump
  5. BARNES BUS Series
  6. Installation and operation manual

Crane BARNES BUS Series Installation And Operation Manual

Battery backup sump pump
Hide thumbs

Advertisement

Quick Links

Download this manual
INSTALLATION and OPERATION MANUAL
Battery Backup Sump Pump
IMPORTANT!
Read all instructions in this manual before operating pump.
As a result of Crane Pumps & Systems, Inc., constant product improvement program,
product changes may occur. As such Crane Pumps & Systems reserves the right to
change product without prior written notifi cation.
A Crane Co. Company
420 Third Street
Piqua, Ohio 45356
Phone: (937) 778-8947
Fax: (937) 773-7157
www.cranepumps.com
Manual Index
BARNES
BARNES
83 West Drive, Bramton
Ontario, Canada L6T 2J6
Phone: (905) 457-6223
Fax: (905) 457-2650
®
Series:
BUS
Form No. 1806006-Rev. F

Advertisement

loading
Need help?

Need help?

Do you have a question about the BARNES BUS Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Crane BARNES BUS Series

Summary of Contents for Crane BARNES BUS Series

  • Page 1 Read all instructions in this manual before operating pump. As a result of Crane Pumps & Systems, Inc., constant product improvement program, product changes may occur. As such Crane Pumps & Systems reserves the right to change product without prior written notifi cation.

  • Page 2: Table Of Contents

    Other brand and product names are trademarks or registered trademarks of their respective holders. ® Barnes is a registered trademark of Crane Pumps & Systems, Inc 1998, 2002, 9/05, 9/06 Alteration Rights Reserved...
  • Page 3 DISCHARGE ....... 1¼” NPT, Female, Vertical The BUS recharges automatically when power is restored LIQUID TEMPERATURE .....150°F (66°C) Continuous and monitors battery and power conditions constantly. It will PUMP HOUSING ......Non-corrosive, may be also detect irregularities, sounds an alarm and pinpoints used in fresh or salt water (resulting from water softener problems and solutions on the control panel.

  • Page 4: Installation Instructions

    Introduction The Barnes Battery Back-up System is a battery-operated sump pump. It is de-signed as an emergency back- up system to support your regular AC sump pump, and it will automatically begin pumping if your main AC pump fails. Should any malfunction or emergency occur that involves the sump pump, the battery, or the AC power, your battery back-up system...
  • Page 5 METHOD A: Whenever possible, install your Battery 4. Attach a rubber union (not included) DIRECT DISCHARGE TO THE Back-up System with a direct discharge to the top of the 1-1/4” pipe. This will OUTSIDE OF THE BUILDING to the outdoors. By using this method, allow the pump to be removed FOR WIDE SUMP PITS (Diagram A) there will always be an outlet for the...

  • Page 6: Direct Discharge To Outside

    Pump & Pipe The path of the rest of the pipe and the details of each Installation Instructions installation will vary. Using sound plumbing practices, try to (Direct Discharge to Outside) route the discharge pipe to an exterior wall via the shortest path with the fewest turns.

  • Page 7: Hookup To Existing Storm Sewer

    Pump & Pipe If there is no check valve on the main AC pump, one Installation Instructions must be installed at this time. Then install a “Y” (Hookup to Existing Storm Sewer) connector above the check valve on the discharge pipe for the main AC pump.

  • Page 8: Hookup To Existing Storm Sewer

    Pump & Pipe 5. If there is no check valve on the main AC pump, one must Installation Instructions be installed at this time. Then install a “Y” connector above (Hookup to Existing Storm Sewer) the check valve on the discharge pipe for the main AC pump.

  • Page 9: Hooking Up The Pump

    Control Unit Hookup post of the battery or the alarm will sound continuously. The Battery Back-up System will not warn you if the fl uid When you position the control unit, be sure the charger cord level is low in this confi guration. You will need to check will reach the AC power outlet and the pump cable and the your battery monthly to see if it needs water.

  • Page 10: Water

    Understanding the Warnings & Check the charger plug that fi ts into the 4. Lower the pump into the sump Alarms rear panel of the control unit. Make sure and reconnect the rubber union or it is securely plugged into the control check valve.

  • Page 11: Battery

    TEST BUTTON In this condition, when the AC power 4. Replace the battery cables, is returned to the unit, a “Battery” BLACK to the POSITIVE (+) post, The TEST button may be used to alarm will continue to sound. The and WHITE to the NEGATIVE (-) check the pump and system.
  • Page 12 RETURNED GOODS RETURN OF MERCHANDISE REQUIRES A “RETURNED GOODS AUTHORIZATION”. CONTACT YOUR LOCAL CRANE PUMPS & SYSTEMS, INC. DISTRIBUTOR. Products Returned Must Be Cleaned, Sanitized, Or Decontaminated As Necessary Prior To Shipment, To Insure That Employees Will Not Be Exposed To Health Hazards In Handling Said Material.
  • Page 13 Notes...
  • Page 14 Notes...
  • Page 15 Your product is covered by the enclosed Warranty. Complete the Warranty Registration Form and return to Crane Pumps & Systems, Inc. Warranty Service Group If you have a claim under the provision of the warranty, contact your local Crane Pumps & Systems, Inc. Distributor.

  • Page 16: Piqua, Ohio

    FOLD HERE AND TAPE, DO NOT STAPLE PLACE STAMP HERE CRANE PUMPS & SYSTEMS, INC. WARRANTY SERVICE GROUP 420 THIRD STREET PIQUA, OHIO 45356 - U.S.A.