Cisco ON100 Network Agent Quick Start Manual page 7

If you are using a PoE port to supply power to the OnPlus Network
S 2
TEP
Agent, make sure that the cable from the unit to the PoE port is
connected.
Slide the power switch on the back panel of the unit to the On
S 3
TEP
position ( | ) to begin the installation.
The OnPlus Network Agent does not automatically power on
N
OTE
when it is connected to a PoE-enabled LAN port.
Depending on the speed of the Internet connection, it usually takes
from 10 to 20 minutes for the OnPlus Network Agent to be ready
for the initial activation. If the base software image on the device is
current, this step may not take as long.
During this time, the OnPlus Network Agent:
• Acquires a LAN IP address using DHCP
• Connects to the Internet and downloads the current base
software image
• Upgrades its software
You can monitor the progress of the initial startup by looking at the
LEDs located on the front panel of the unit. See the
Network Agent Status LEDs" section on page 8
information.
The OnPlus Network Agent is ready for activation when the
S 4
TEP
STATUS 1 LED on the front panel is lit Steady Green and the
STATUS 2 LED is Off.
IMPORTANT
Amber and Blinking Amber for more than two minutes, it indicates
that the OnPlus Network Agent has failed to obtain an IP address
using DHCP. Make sure that the DHCP server is functioning and that
IP addresses are available in the DHCP pool.
To continue, go to
Cisco OnPlus Portal, page
Cisco ON100 Network Agent Quick Start Guide
If the STATUS 1 and STATUS 2 LEDs are lit Steady
Activating the OnPlus Network Agent with the
9.
"OnPlus
for more
7