Network - Panasonic CJ-HDR216A Quick Start Manual

2.8 Network

The interface is shown as in Figure 2-36.

IP Version: There are two options: IPv4 and IPv6. Right now, system supports these two IP
address format and you can access via them.

MAC Address: The host in the LAN can get a unique MAC address. It is for you to access in
the LAN. It is read-only.

DHCP: It is to auto search IP. When enable DHCP function, you cannot modify IP
Address/Subnet Mask/Gateway. These values are from DHCP function. If you have not
enabled DHCP function, IP Address/Subnet Mask/Gateway display as zero. You need to
disable DHCP function to view current IP information.

IP Address: Here you can input the corresponding number to input IP address. Then you can
set the corresponding subnet mask the default gateway.

Gateway: Here you can input the default gateway. Please note system needs to check the
validity of all IPv6 addresses. The IP address and the default gateway shall be in the same IP
section. That is to say, the specified length of the subnet prefix shall have the same string.

Preferred DNS server: DNS server IP address.

Alternate DNS server: DNS server alternate address.

MTU: It is to set MTU value of the network adapter. The value ranges from 1280-1500 bytes.
The default setup is 1500 bytes. Please note MTU modification may result in network adapter
reboot and network becomes off. That is to say, MTU modification can affect current network
service. System may pop up dialogue box for you to confirm setup when you want to change
MTU setup. Click OK button to confirm current reboot, or you can click Cancel button to
terminate current modification. Before the modification, you can check the MTU of the
gateway; the MTU of the DVR shall be the same as or is lower than the MTU of the gateway.
Please input the
corresponding information
here, if you just upload the
image FTP.
Figure 2-35
41