Page 1
d MINAL MENT _AT-10 SERIE TALLATIO UIDE xCL_AT‐100 s series: xCL_AT‐ ‐100‐17U xCL_ AT T‐100‐17E ...
Page 2
1. P ACKAG ONTENT AT-100 Power ada aptor USB cab Privacy Sh h ield Paper Roll 2. D EVICE VERVIEW AT‐100 K ey Buttons & Interfac ce Ports (Figure 1): FRONT REAR Figure 1 ...
Page 3
USB port (type C) for charging Battery Compartment ■ AT-100 power spec: Input: 5V DC, 2A ■ Power Adapter spec: Input: 100 ~240 Vac Output: 5V DC, 2A This symbol is intended to alert the user before starting using the POS. Caution: Use only the AC adapter approved and provided by XAC Automation Corporation for use with this device. Use of any other AC adapter may cause a risk of fire or explosion. Operating Temperature: 0 C to 40 C 3. P OWER FF THE EVICE ...
4. U SING THE AGNETIC EADER Swipe the card through the slot with magnetic stripe side facing the same direction as the display. (Figure 3) Figure 3 5. U IC C SING THE EADER Insert an IC card into the slot (Figure 4) with the chip side facing the same direction as the touch panel (Figure 5). ...
Page 5
Figure 6 7. U SING THE ONTACTLESS EADER Tap the contactless card on top of the contactless logo (Figure 7). Figure 7 ...
Page 6
Figure 8 Figure 9 Bottom Cover Removal Warning When removing the bottom cover and screws for the purposes of changing battery, remember to put back the cover and screws before power on the POS. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. Warning for internal battery pack To reduce risk of fire or burns: Do not attempt to open, disassemble, or service the battery pack. Do not crush, puncture, short external contacts, or dispose of in fire or water. o Do not heat above 60 C 9. I NSERT CARD After removing the battery, the user can find SAM *2 (left) slots at the bottom side of device. ...
Page 7
Figure 11 EDERAL OMMUNICATION OMMISSION NTERFERENCE TATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 8
FCC ID: MQT-AT10017U. XAC Automation Corporation 886-3-577-2738 The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation.