Table of Contents
Advertisement
Operating Manual
WARNING! THE MAIN FIXTURE ASSEMBLY
NTA5000 WEIGHS 27KGS AND
SHOULD NOT BE LIFTED BY
ONE PERSON ALONE; USE 2
PEOPLE WHEN LIFTING ON OR
OFF THE MACHINE.
5.
Lift the fixture assembly onto the mounting
bracket support post and slide into position.
Secure with four screws through the side
brackets (two each side).
6.
Route
the
four
(numbered 1 to 4) through the guard and
connect to the injector fixture lines and to
four of the metering unit lines. We will use
the convention of numbering the injector
positions 1 to 4 from left to right as shown.
7.
Connect the high pressure hose A079B112
from the guard dump valve to the rail entry
port.
The fixture is now ready to accept the required
injector-specific
fitting
TIB195/11).
2.2 Upgrade to AE31 Pump Control Unit
The AE31 CR Pump Test Box (from the HF1130 kit) requires a software update to work with the
injector test box. Refer to the separate instructions in kit HS239 (supplied).
2.3 Injector Control Unit
2.3.1 Fitting/Installation
The AE32 injector test box is designed to be fixed
onto the AE31 pump test box.
1.
Unscrew the three bottom feet from the
AE31.
2.
Offer up the AE32 and re-fit the feet (using
the three longer M4 screws supplied)
screwing through the holes in the extended
rear panel.
10
THIS IS AN UNCONTROLLED DOCUMENT downloaded by Lukas Matuska on 16 Feb 2016
Any technical intervention requires certified Hartridge training. Contact Hartridge Ltd for details.
delivery
line
hoses
accessories
(see
HARTRIDGE LIMITED
1
2
3
AE31
HL030(EN), Issue 1, June 2005
4
Advertisement
Table of Contents
