Unpacking (I) - Siemens 3AH3 Operating Instructions Manual

Transport, storage and packing
Transporting with packing
Checking the transport
Working equipment
Opening the transport unit
6
Transport the transport unit to the installation site or storage location
• with a fork lift or
• with sling gear suspended from a crane
- at an angle of twist of approx. 60° or
- with a spreader bar.
After receipt of delivery:
• Check transport unit for damage.
unit
• Major damage must be documented photographically.
• Ensure that any damage to the transport unit is confirmed by the transport com-
pany.

Unpacking (I)

Required tools:
- Knife/scissors
- Lifting equipment with lifting gear
- Pliers or lever.
CAUTION
Risk of injury from sharp edges!
Fasteners may break, leaving sharp edges.
Always use a suitable tool to lever out fasteners.
Note
Do not cut open or damage the carton, since it is designed to be reused and
because of the belt straps located underneath.
Belt straps could be severed on the pallet floor when cutting open the carton.
The vacuum circuit-breaker is attached to the pallet with belt straps. It is not pos-
sible to transport the vacuum circuit-breaker on the pallet without using belt straps
(see Fig. 5).
Fig. 3 Removing the carton
• Place the transport unit on a level, non-slip and pressure-resistant surface.
• Remove lifting gear or transport means.
• Remove plastic wrap.
• Lever out fasteners from the carton and lift off carton.
9229 9860 176 0E
2013-08-22