Appendix E: Touch Re-Packaging Instructions - 3D Systems Touch User Manual

9

APPENDIX E: TOUCH RE-PACKAGING INSTRUCTIONS

If you need to transport or ship the haptic device, please follow these packaging guidelines to reduce the risk of
damage to the device.
IMPORTANT: Remember the haptic device is a sensitive piece of electronic equipment and must be handled with
care. Lifting the device by any of the moving parts may adversely affect the unit's performance and risks damaging
the device. The haptic device has a limited range of motion. Forcing the device past these limits risks damaging the
device. If you have not already done so, please review the section on
Shipping Checklist/Packing Materials:
You will need the following items to ship the device safely. The following are the packaging materials with which the
device was originally shipped:
• 1 Medium shipping box
• 1 Set of foam inserts (cradles the device)
• Shipping Tray
• Packing tape
Packing the Device and Accessories:
• If necessary, reassemble the box and arrange the foam inserts. Fit the bottom foam insert into the bottom of the box.
• Orient the Touch device to fit neatly inside the foam insert. You may need to grasp the Touch device by the upper arm, the piece
with the oblong cutout, in order to position it properly. DO NOT grab the stylus.
• Gently lower the Touch device into the insert, while maintaining alignment of the Touch arm to the cutout.
• Ensure that the Touch device is fully seated by pressing firmly on the Touch label.
• Check to see that the Touch arm is fully seated by carefully pressing on the elbow joint.
• Place the top half of foam insert over the Touch device.
• Place the stylus, power supply, power cord, and Ethernet cable into the Shipping Tray on the top of the foam insert.
• Place the Shipping Tray over the foam insert.
• Close the box and tape shut.
20
3D Systems, Inc.
Using the 3D Systems Touch Device.
30-0433 Rev. A