Introduction; Copyright; Fcc Notice; Compliance - 3D Systems Touch User Manual

1

INTRODUCTION

Copyright

1.1
©2018 3D Systems, Inc. All rights reserved. The content of this manual is furnished for informational use only, is
subject to change without notice, and should not be construed as a commitment by 3D Systems, Inc. This document
is copyrighted and contains proprietary information that is property of 3D Systems, Inc. The 3D Systems Touch, 3D
Systems TouchX, 3D Systems OpenHaptics, Phantom, Geomagic, Phantom Desktop, Phantom Omni, Touch 3D Stylus,
Geomagic OpenHaptics, Sensable, 3D Systems, and 3D Systems logo are registered trademarks of 3D Systems. Use
of the 3dsystems.com website constitutes acceptance of its Terms of Condition and Privacy Policy. Any similarity of
likeness of the names, places, and/or events in this publication to those of any individual, living or dead, place, event,
or that of any group or association is purely coincidental and unintentional.

FCC Notice

1.2
Touch
This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at their expense.
TouchX
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Compliance

1.3
Touch
This equipment conforms with EN 61326-1:2013, IEC 61000-3-2:2014, IEC 61000-3-3:2013, and EN 60950-1:2006
(Second Edition) +A11:2009 +A1:2010 +A12:2011 +A2:2013 and meets the requirements of the applicable EU
Directives.
TouchX
This section is not applicable for the TouchX as it is a Class B device.
1
3D Systems, Inc.
30-0433 Rev. A