Table of Contents
Advertisement
7
APPENDIX C: ADVANCED SETUP STEPS
Run 3D Systems Touch Setup (Optional)
If you have already configured the device using smart setup, please skip this step. Touch Setup and Diagnostic
tools are for advanced users.
NOTE: The following statement is only applicable for LAN devices.
In this section you will identify your 3D Systems haptic device and pair it with your host PC. This process only needs to
be executed once. There is a safety key exchange during the pairing process. The safety key will be saved to host PC
hard drive and the NV-Ram of the 3D Systems Touch after the pairing process is properly done.
NOTE: For existing users, see the following section before proceeding:
UPGRADING TO 3D SYSTEMS TOUCH OR TOUCH
1.
Double-click the 3D Systems Touch Setup icon on your desktop, or if you chose not to install desktop shortcuts click
Start>All Programs>3D Systems>3D Systems Touch>3D Systems Touch Setup.
Make sure that the correct 3D Systems Touch Model (Touch or TouchX) is selected on the Hardware tab. From the
Host Name drop-down list on the Hardware Tab, do the following:
a. Match the name of the device or the serial number on the bottom of the device with a device in the list.
2.
After you have identified your device you will need to lock or "Pair" it with your host PC. NOTE: This step is applicable
to LAN Devices only.
a. Press the Pair button on the back of your 3D Systems Touch device. The device and your computer are now
paired together.
NOTE: You will only need to Pair the device again if you move the device to a different computer. If you run out of
time, a timeout error will appear. In this case repeat steps 4 and 5 again.
3.
Click OK to apply the pairing and exit the Setup dialog.
16
3D Systems, Inc.
X.
The 3D Systems Touch Setup Window
IMPORTANT INFORMATION FOR USERS
30-0433 Rev. A
Hide quick links:
Advertisement
Table of Contents
