Advertisement
Quick Links
1
Download and Install drivers
Download the Touch Device Driver from
www.3dsystems.com/haptics-devices/
touch-x/documents. Follow the Install
Wizard instructions to install the Touch
Device Drivers. Reboot your computer
after installing drivers to avoid any
performance issues.
4
Run Touch Smart Setup
After connecting the device, run the
Touch Smart Setup application. To
calibrate the device, slowly move the arm
to the right and left, up and down, in and
out. Indicator boxes will turn
each axis is calibrated.
NOTE: Geomagic Freeform or Geomagic Sculpt cannot be open while running the Smart Setup.
©2018 3D Systems Inc. All rights reserved. The 3D Systems logo and stylized text are registered trademarks of 3D Systems Inc.
All other trademarks are the property of their respective owners.
Please refer to the 3D Systems Touch Device User Guide for installation, safety, and
proper operating and handling instructions. The User Guide can be found here:
www.3dsystems.com/haptics-devices/touch-x/documents
Phone:
1-978-494-8241
E-mail:
Software.Support.Americas@3DSystems.com
Grip &
Lift
Remove device from packaging
Grab the polybag and remove the device
from the packaging. Lift the device out of
the foam by grasping the back and secur-
ing the rotating head as shown above.
DO NOT lift the device by grasping the
stylus or arm (this can damage the device).
Perform verification tests
Perform the steps presented in the Sphere
Simulation and Hollow Cube Simulation
tests to verify proper device performance.
green
when
Touch X
Arm
Stylus
Secure
Joints
2
Connect and power up device
Connect the power cord to the power sup-
ply and to an available outlet. Then plug in
the power supply to the device. The LED at
the top should quickly blink twice.
Connect the provided USB cable to both
the device and the host computer.
5
Save configuration
When these tests have been completed,
select Save Configuration to complete
the Touch Smart Setup process.
™
To Wall
Outlet
To USB
Port
3
6
Connect
Power
Supply
30-0432 Rev. A
Advertisement
Related Manuals for 3D Systems Touch X
Summary of Contents for 3D Systems Touch X
- Page 1 NOTE: Geomagic Freeform or Geomagic Sculpt cannot be open while running the Smart Setup. ©2018 3D Systems Inc. All rights reserved. The 3D Systems logo and stylized text are registered trademarks of 3D Systems Inc. 30-0432 Rev. A...
- Page 2 User Guide. 3D Systems will promptly repair or replace the Touch X, if required, to make it free of defects during the warranty period. This warranty excludes repairs required during the warranty period because of abnormal use or conditions (such as riots, floods, misuse, neglect or improper service by anyone except 3D Systems or its authorized service provider).