Switching The Projector On And Off; Switch On From Standby; Switching Off And Returning To Standby - Sim2 GRAND CINEMA HT HT5000 User And Installation Manual

5 SwiTChiNg ThE PROJECTOR ON AND Off

wARNiNg: Connect the projector to a power supply with a
nominal voltage within the following values: 100-240 V AC,
50/60 hz. it must be earthed (fig. 8).
Power Switch:
Position I: On
Position 0: Off
Power Plug
In position i the projector will initialise itself (red and green leds
on) and then goes into standby mode (red led on) (Fig. 9).
Fused
Power Socket
Fig. 8
Fig. 9

SwiTCh ON fROM STANDBY

With the remote control press one of the keys:
- 0 to select the last imput selectet after last switching of.
- 1-9 to select the correspondent imput
With the keypad: press the ON/OFF button.
0
When the unit is switched on from standby the lamp switches
on; after a brief period of warming up, the image displays (blue
led on). The projected image comes from the input selected
when the unit was last switched off (Fig. 10).
if a very short time has passed since the unit was last switched
off, the lamp may not switch on because it is too hot.
Just wait a few minutes for the lamp to cool down sufficien-
tly.

SwiTChiNg Off AND RETURNiNg TO STANDBY

With the remote control: press
With the keypad: press ON/OFF button.
When switching off, the projector goes into stand-by mode and
stores the input selection at the time of switch-off.
The fans keep running until the lamp cools down (blue and
red leds on), after which they automatically switch off. Do not
switch off the projector with the power switch until the fans
have stopped running.
ht5000
Fig. 10
.
11