Table of Contents
Advertisement
4
Install the:
a
battery
b
base cover
5
Follow the procedure in
Input output board
Removing the Input and Output board
1
Follow the procedure in
2
Remove the:
a
base cover
b
battery
c
system fan
3
To remove the IO board:
a
Peel the adhesive tape that secures the IO board connector [1].
b Open the IO board connector latch and disconnect IO board cable from the connector on the IO board [2].
c
Disconnect the fingerprint reader cable from the connector on the IO board [3].
NOTE:
This step is applicable only to the systems that are shipped with power button with fingerprint reader.
d Remove the two (M2x3) screws that secure the IO board to the palmrest and keyboard assembly [4].
e
Lift the IO board away from the system [5].
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
43
Advertisement
Table of Contents
