Labrie Expert 2000 Maintenance Manual page 122

114 C 4
HAPTER
Troubleshooting
Problem
The packer does
not start when you
press the green
button.
Problem
The yellow
R
ETRACT
button functions as
a press-and-hold
button instead of a
just-press button.
Problem
The green
S
TART
button
C
YCLE
functions as a
press-and-hold
button instead of a
just-press button.
Problem
The packer moves
forward but stops
at the end of the
stroke.
Possible cause(s)
The PTO switch is off.
There is a red emergency
button pressed-in.
S
TOP
The packer controls station
selector switch is not on
the correct station.
Possible cause(s)
There is a hydraulic
defficiency.
There is a defective
electrical harness.
The packer module is
deffective.
Possible cause(s)
There is a deffective
electrical harness.
The packer module is
deffective.
Possible cause(s)
The packer wear plates are
worn out.
The packer extension limit
switch needs adjustment.
Solution(s)
Turn on the PTO switch.
Verify that all red emergency
pulled out.
Verify the packer controls station selector switch;
it must be turned to the corresponding station.
Solution(s)
Verify and make sure the hydraulic pressure is at
the proper level.
Apply the electrical system troubleshooting
between the packer module and the
corresponding packer control station.
Troubleshoot the packer module. Call LabriePlus
for details.
Solution(s)
Apply the electrical system troubleshooting
between the packer module and the
corresponding packer control station. Call
LabriePlus for details.
Apply the packer module trobleshooting. Call
LabriePlus for details.
Solution(s)
Replace the wear plates.
Adjust the packer extension limit switch.
buttons are
S
TOP