Snooze Function; Adjusting The Display Brightness - Silvercrest KH 2217 Operating Instructions Manual

Snooze function

With the button
function for a period of between 1 and 30 minutes, this period being
programmed by yourself (see next section). The factory setting is
9 minutes.
On the expiration of this period the alarm tone or radio sounds again
(Automatic after-call). The function can be repeated up to six times. After
that, the alarm first sounds on the following day.
The automatic after-call allows itself to be individually adjusted to
between 1 and 30 minutes. The radio is switched off and the automatic
after-call is not active.
1. Press and hold the button
minute indication appears on the display.
2. Press the button
3. As soon as the desired after-call period is displayed, release the
button.
4. Press the button
The programmed after-call period is taken over.
Note:
Should a second alarm time be pending during an activated snooze
function, the second alarm time will eventually switch itself on and, if need
be, the snooze function must once again be reactivated.

Adjusting the display brightness

Mains power operation:
1. Press the button
The display brightness changes itself as follows:
Bright>Medium>Dark>Bright
SNOOZE/ DISPLAY DIMMER
SNOOZE/DISPLAY DIMMER
MIN+ SET
to programme the minutes.
SNOOZE/DISPLAY DIMMER
SNOOZE/DISPLAY DIMMER
you can interrupt the alarm
.
at intervals of 2 seconds.
- 17 -
until SNO and the