Resetting Welding Parameters To The Factory Settings - EWM Pico 300 cel Operating Instructions Manual

7.2

Resetting welding parameters to the factory settings

All customised welding parameters that are stored will be replaced by the factory settings.
Display
099-002032-EW501
15.10.2018
RESET
0
l
Setting/selection
Calibration
The machine will be calibrated for approx 2 seconds each time it is switched on.
Initialising
Keep the push-button pressed until
Resetting welding parameters to the factory settings
AMP
+
VOLT
Figure 7-1
is shown on the display.
Rectifying faults
+
37