Commissioning; General Notes On Handling; Initial Commissioning - wtw photoLab 7100 VIS Operating Manual

Commissioning

Packing
12
3 Commissioning
3.1

General notes on handling

®
The photoLab 7100 VIS photometer is an optical precision meter. There-
fore, it should always be handled with care, especially in mobile use. Always
protect the meter from conditions that could damage the mechanical, optical
and electronic components. Heed the following points especially:
 The temperature and humidity during operation and storage must be
within the limits specified in chapter 7 T
 The following influences always have to be avoided with the meter:
– Extreme dust, moisture and wetness
– Exposure to intensive light and heat
– Fumes that are corrosive or contain high concentrations of solvents.
 For measuring, the meter must be placed on a flat surface.
 Spilled liquid or other material should be removed immediately (see sec-
tion 5.3 C
LEANING
 If a cell has broken in the cell shaft, the cell shaft should be cleaned imme-
diately (see section 6.1 A
 The cell shaft should always be closed when the photometer is not used.
 For the instrument to be transported the cell shaft has to be empty.
 For mobile used we recommend using the suitable transport case
FC spectral 6000 .
3.2

Initial commissioning

Perform the following activities:
 Insert the buffer batteries (see section 3.2.1)
 Connect the power supply (see section 3.2.2)
 Switch on the photometer (see section 3.2.3)
 Set the language (see section 3.2.3)
 Set the date and time (see section 3.2.4)
 Carry out a zero adjustment (see section 4.3)
This photometer is sent out in a protective transport packing.
CAUTION
Keep the original packing including the inner packing to protect the in-
strument against hard shocks if it has to be transported.
).
CTIONS IN THE CASE OF A BROKEN CELL
photoLab
.
ECHNICAL DATA
ba77095e03
®
7100 VIS
).
10/2017