Safety Notice; General - TagMaster S1566 Installation Manual

TagMaster AB
HW Installation Guide
5

SAFETY NOTICE

5.1

General

This Installation Manual shall be carefully read before any installation works is performed.
Special attention shall be paid to this page and the statements in boxes throughout the manual.
The contents of this document are not binding. If any significant difference is found between the
product and this document, please contact TagMaster AB for further information
We reserve the right to modify products without amending this document or advising the user.
We recommend using personnel authorised by TagMaster for all installation, service and repair
and the use of TagMaster genuine spare parts. TagMaster AB will not otherwise assume
responsibility for the materials used, the work performed or any consequences of the same.
Check the contents of the shipment for completeness and possible damage. If the contents are
incomplete or damaged, a claim should be filed with the carrier immediately and the TagMaster
Sales or Service organisation or the TagMaster representative should be notified in order to
facilitate repair or replacement of the equipment.
The equipment described in this manual is designed to be used by properly trained personnel
only. Installation, adjustments and maintenance of the exposed equipment shall be carried out by
qualified personnel who are aware of the hazards involved and who are qualified for electrical
installations.
For correct and safe use of this equipment, it is essential that both operating and service
personnel follow generally accepted safety procedures in addition to the safety precautions
specified in this manual.
The emitted power level from a TagMaster communicator is less than 10mW EIRP. This power
level is defined as very low and is far below the European levels that would require any form of
analysis when considering health risks. For comparison purposes, the emitted power level from a
TagMaster communicator is significantly less than that emitted by a typical mobile telephone.
TagMaster uses a radio frequency technology, which has been tested and conforms to the
requirements of the European CE mark approval for Short Range Devices.
To conclude, there is no risk to personal safety when working with or in close proximity to the
TagMaster communicator.
SAFETY NOTICE Manual issue 01
9