Table of Contents
Advertisement
Modular Optical Tweezers
Chapter 2
Safety
All statements regarding safety of operation and technical data in this instruction manual will only apply when the
unit is operated correctly.
!
Changing the laser diode drive current limit or the TEC drive current on the laser control unit can
result in permanent damage to the laser if the limit values of the laser are exceeded.
!
The modular optical tweezers system enables the user to access the laser beam without using
tools, e.g. by removing the filter cube from the system. Use proper laser safety precaution at all
times and check with your local laser safety officer regarding necessary precautions.
!
The included laser diode is sold as a component. The purchaser assumes the responsibility to
comply with US 21 CFR 1040.10, US 21 CFR 1040.11, and IEC 60825-1, Edition 1.2
!
Latex gloves should be worn to prevent oil from fingers from reaching all optical surfaces.
Make sure you use appropriate laser safety glasses during operation.
Avoid Exposure – ASE and laser radiation emitted from apertures.
Page 2
WARNING
WARNING
CAUTION
CAUTION
WARNING
Never look directly into beam
Chapter 2: Safety
!
!
!
!
19590-D02
Advertisement
Table of Contents
Need help?
Do you have a question about the OTKB/M and is the answer not in the manual?
Questions and answers