Table of Contents
Advertisement
Save the alignment settings to the system by
entering the following command
19
#SAV
Note! After initializing has completed the GD1 will enter Measuring Mode (normal
operational mode). The initialization can take up to 5 minutes.
Note! As a default the zero filter is activated. The zero filter removes any fluctuations below
14 ppm*m (7% FS). So the analogue output will show 4 mA as long as the measurement is
below 14 ppm*m.
GD1
Fine tuning finished!
Page 34 of 76
Terminal response:
IM:OK
This saves the current settings,
exits Service Mode and initialize
(reboots) the system.
850-816926-EN R06
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GD1 MK3 and is the answer not in the manual?