Install The Leg And Wheel Assemblies; Install The Guide Track - Kreg Adaptive Cutting System Project Table Kit Owner's Manual

Install the Leg and Wheel Assemblies

(1) Turn the project table upside down
on a flat surface, making sure the
table tracks do not fall out.
(2) Thread nuts onto the two
protruding bolts closest to the
aluminum frame that fasten each of
the table tracks.
ATTENTION Before tightening the bolts, ensure
:
the table-track ends are flush with the table-top edge.
(3) Install leg assemblies 1 and 2 and
the wheel assembly as instructed in
your original Adaptive Cutting System
Project Table owner's manual.

Install the Guide Track

(1) Turn the Project Table right side
up and install the hinge-mounting
plates, hinges, and guide track, and
recalibrate your system as instructed
in your original Adaptive Cutting
System Project Table owner's manual.
ATTENTION Two people are required to lift
:
the Project Table.
SETUP
1
1
3
2
3
1