Setup - Kreg Adaptive Cutting System Project Table Kit Owner's Manual

SETUP

Remove the old Project Table Top
(1) Remove the guide track, hinges,
hinge-mounting plates, and all
corresponding hardware. Retain all
1
components for reassembly.
(2) Place the Project Table upside down
on a flat surface that will support the
table tracks when the nuts securing
them to the table top are removed.
1
ATTENTION Two people are required to lift
:
the Project Table.
(3) Remove all nuts, bar brackets,
and U-bolts fastening leg assemblies
1 and 2; the wheel assembly; and the
four nuts attaching the table tracks to the Project Table top. Retain all nuts, bar brackets, and U-bolts for reassembly.
3
2
3