Related Manuals for Kreg Adaptive Cutting System Project Table Kit
Summary of Contents for Kreg Adaptive Cutting System Project Table Kit
- Page 1 Owner’s Manual ADAPTIVE SYSTEM Guide d’utilisation / Manual del propietario PROJECT TABLE REPLACEMENT TOP IS COVERED IN THIS MANUAL 01/2019 NK9396...
- Page 2 BEFORE YOU BEGIN Check the contents of the carton to ensure you have all parts in the quantities listed. Should any part be missing, contact Kreg Customer Service. Refer to your original Adaptive Cutting System Project Table owner’s manual for part identification and reassembly instructions.
- Page 3 SETUP Remove the old Project Table Top (1) Remove the guide track, hinges, hinge-mounting plates, and all corresponding hardware. Retain all components for reassembly. (2) Place the Project Table upside down on a flat surface that will support the table tracks when the nuts securing them to the table top are removed.
- Page 4 SETUP Remove the old Project Table Top (4) Turn the table top right side up, making sure the table tracks do not fall out and get damaged. (5) Lift the table tracks out of the table- Retaining Plates top slots. Leave the table-track bolts and plastic retaining plates in place.
- Page 5 SETUP Install the Leg and Wheel Assemblies (1) Turn the project table upside down on a flat surface, making sure the table tracks do not fall out. (2) Thread nuts onto the two protruding bolts closest to the aluminum frame that fasten each of the table tracks.
- Page 6 201 Campus Dr, Huxley, IA 50124 Kreg Enterprises Inc. For assistance with any Kreg product, contact us through our Web site or call Customer Service. Si vous avez besoin d’aide concernant les produits Kreg, communiquez avec nous sur notre site Web ou appelez notre service à la clientèle.
Need help?
Do you have a question about the Adaptive Cutting System Project Table Kit and is the answer not in the manual?
Questions and answers