Frima VarioCooking Center 112T Original Installation Instructions page 25

Electrical connection
1
2
3
Observe the colour coding of the
conductors. Incorrect connection may lead to
electrical shock or damage the equipment.
General instructions: see previous page.
The connection terminals are located behind the rear
face, in the electrical compartment. See detail in Fig.
1 & 2
Detail
(1)
(2)
(3)
Demonstration mode (without heating, wit-
hout water)
(Also see chapter Installation Options > Demonstration
Mode)
Our appliances can be connected in demonstra-
tion mode (single-phase supply). Depending on the
demonstration mode chosen, the heating, tank filling
and movements are de-activated.
Procedure
(1). Connect the appliance.
(2). Start the appliance and immediately activate the
demonstration mode of your choice.
For single-phase connection use the electrical dia-
gram accompanying the appliance. You must connect
the L2 terminals for phase and N for neutral. (Yellow
green for earth)
For the choice of demonstration mode, consult chap-
ter Installation Options.
- 25 -
Rear face, electrical compartment
Electrical connection cable gland
Equipotential connection
Fig. 1
Fig. 2
v03