Electrical Connection - Frima VarioCooking Center 112T Original Installation Instructions

Electrical connection

General points and safety
Regulations
• Connect the appliances in accordance with the
installation instructions and the instructions
on the data plate (See description in chapter
"data plate").
• Appliances must be connected to an electricity
supply network which meets the standards in
force in your country.
• Follow the recommendations of the local elec-
tricity supply company.
• We recommend using a 30mA residual current
device.
• Provide an accessible all-pole circuit breaker
with a 3 mm minimum contact gap.
• Applicable standards: EN 60335, IEC 60335
Safety
Electrocution hazard !
» Only trained persons should
carry out the electrical connection.
» At the time of installation,
ensure that the available electricity sup-
ply corresponds to that intended for the
appliance. Consult the data plate.
» Make sure all power is swit-
ched off using an external switch. The
switch on the appliance is not suffi-
cient, certain parts will still be live.
v03
Mains connection cable:
• Electrical data: see page 26
• Connection of appliances, for values and
connection points see the following pages 25
- 26 and the technical sheets on page 12 - 15.
• Appliances may be connected permanently or
using a suitable power outlet.
• Before plugging in or unplugging the connec-
tion cable, make sure that the appliance is
switched off.
• As a minimum, connect a HO7RN-F type cable.
Make sure the cable glands are properly tigh-
tened.
• It is strongly recommended not to use a rigid
cable for connection with our appliance.
• The cross-section of cables also depends on
local regulations. See chapter "Connection
values" paragraph "Cable cross-sections".
Electrical diagram
• The electrical diagram is in a pocket located in
the technical compartment of the appliance,
behind the removable partition. See section:
installation, opening appliances.
After use, make sure you return it to
this location.
- 24 -