MP880W Modem User Guide
Note: Connector part numbers:
39-01-2040 or 39-01-2045. Pins
part number: 39-00-0039.
32
Note: Electrical installations are potentially dangerous and should be
performed by personnel thoroughly trained in safe electrical wiring
procedures for vehicles.
Power connector
The power harness connects to the MP modem with a Molex
connector.
Power connector (Molex) pinouts
The pinouts for the Molex connector on the power harness are:
White wire
(Ignition sense)
Red wire
(Battery)
Figure 3-6: Pinouts for the power harness.
The battery (red) and ignition sense (white) wires in the power
harness include 5 A fuses. The black ground wire is not fused.
(See "Ground the power harness" on page 34.) Replacement
power harnesses are available from Sierra Wireless.
Note: The battery cable used for a car, truck, or other mobile
connection must be less than 3 meters in length.
Vehicle installation
This section applies to installing the MP modem in a vehicle. If
you are installing it in an office, see "Office installation" on
page 35.
Ignition sense on/off wiring
This section only applies to installing an MP modem in a
vehicle. If you are installing the MP modem in an office
building, use the AC/DC adapter.
Unused
Black wire
(Ground)
2130795