Table of Contents
Advertisement
MP 595 Modem User Guide
Note: Electrical installations are
potentially dangerous and
should be performed by
personnel thoroughly trained in
safe electrical wiring procedures
for vehicles.
Note: Power off the MP modem,
your computer, and any other
devices while you are connecting
cables.
24
GPS and I/O options
The MP modem provides support for GPS (Global Positioning
System) and for attaching input/output devices.
GPS. If you plan to use the MP modem's built-in GPS module,
you must connect a GPS antenna using an antenna cable, or
use a combination antenna that can connect to both the GPS
and RF connectors on the MP modem housing.
Other I/O devices. Other devices, such as panic buttons,
sensors, or gauges may also be installed with the MP modem
and connected with an I/O cable to the I/O port. (See
connections"
on page 34.)
Overview of installation steps
The installation process for the MP modem varies depending
on how you plan to use it, where it best fits in your vehicle,
and which of its features you plan to use. The main steps are:
1.
Mount the MP modem.
2.
Mount the antennas and connect the cables.
·
RF antenna and cable.
Additional RF antenna and cable, if you plan to use
·
receive diversity.
·
GPS antenna and cable, if you plan to use GPS.
3.
Connect the power harness.
4.
Connect the cable that will run between the MP modem
and your computer to the MP modem.
Do not connect the cable to the computer until you have
installed the software.
5.
Install the software.
6.
Start 3G Watcher and activate your account.
7.
Test the system.
Install the MP modem
Step 1—Mount the MP modem
The MP modem is usually mounted in the trunk of the vehicle,
but other possibilities are under the dashboard or a seat.
Select a location for the MP modem
When selecting a mounting location, remember the following:
"I/O port
2130795
Advertisement
Table of Contents
