Fig. 30 Changing The Oil Separator Cartridge - KAESER ASK T series Service Manual

Fig. 30
9_5717 20 E
10 Maintenance
10.17 Changing the oil separator cartridge
Changing the oil separator cartridge
Cover
14
Dirt trap
15
Air pipe
16
Fixing screw
17
Changing the oil separator cartridge
1. WARNING!
Compressed air!
Compressed air and devices under pressure can injure or cause death if the contained energy
is released suddenly.
➤ De-pressurise all pressurised components and enclosures.
2. Unscrew the fitting
20
item .
15
3. Unscrew the nut and turn the air pipe
19
4. Remove the cover fixing screws
5. Take out the old oil separator cartridge
cording to environmental protection regulations.
6. Clean all sealing faces.
7. Insert the new oil separator cartridge with gaskets and screw down the cover.
8. Renew the O-ring and strainer in the dirt trap
9. Attach the air pipe to the cover
10. Replace and tighten all fittings.
➤ Dispose of parts and materials contaminated with oil in accordance with environmental
protection regulations.
Starting the machine and carrying out a trial run
1. Close all access doors; replace and secure all removable panels.
2. Open the user's shut-off valve between the machine and the air distribution network.
Service Manual Screw Compressor
ASK T SIGMA CONTROL BASIC
19
20
21
23
and carefully put the parts to one side, then pull out the copper pipe at
to one side.
16
and carefully remove the cover
17
together with the gaskets
23
15
with a new, self-locking nut.
14
Self-locking nut
Screw fitting
Gasket
Oil separator cartridge
.
14
and dispose of ac‐
21
.
79