Memory Card Installation; Memory Card Removal - SYMA Gyro Remote Control Series User Manual

Left/right side flight trim control
Left/right side turning trim control
Memory card installation / removal

Memory card installation

Memory card removal

Note：Do not remove or insert the memory card when the drone is powered on.
While the drone is hovering in the air and
automatically flies left/right, press in on the left
joystick and at the same time push the right
joystick left/right slightly to fine tune the direction.
Don't release the left joystick until the drone is
flying in a stable state.
While the drone is hovering in the air, when the
drone automatically rotates and flies towards the
left/right, press in on the left joystick and at the
same time move joystick to the right or left to
adjust the direction. Don't release the left
joystick until the drone is flying in a stable state.
Put the memory card into the
slot in the tail of the drone as
shown on the left.
Pull the memory card out of the
slot in the tail of the drone as
shown on the left.
-13-