Technical Data; Installation; Mains Supply - ESAB A2 PEK Instruction Manual

GB
3

TECHNICAL DATA

Supply voltage
Power requirement
Engine connections adapted for ESAB's
motors
Speed control
Operating temperature
Transportation temperature
Relative air humidity
Dimensions lxwxh
Weight
Enclosure class
Travel speed
Max manual travel speed
Wire feed speed, filler wire
*) The setting range is dependent on the product used.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration by solid
objects or water. Equipment marked IP23 is designed for indoor and outdoor use.
4

INSTALLATION

The installation must be executed by a professional.
4.1

Mains supply

Note
Mains supply requirements
High power equipment may, due to the primary current drawn from the mains supply, influence the
power quality of the grid. Therefore connection restrictions or requirements regarding the
maximum permissible mains impedance or the required minimum supply capacity at the interface
point to the public grid may apply for some types of equipment (see technical data). In this case it
is the responsibility of the installer or user of the equipment to ensure, by consultation with the
distrubution network operator if necessary, that the equipment may be connected.
be01d1ea
PEK
42 V, 50/60 Hz
Max 900 VA
6 A 100%
Reconnection from motor with pulse sensor
-15° C to + 45 ° C
-20° C to + 55 ° C
Max 95%
246 x 235 x 273 mm
6.6 kg
IP23
0-200 cm/min *)
See separate instruction manual for automatic
welding machines
2.0 m/min
0-2500 cm/min *)
See separate instruction manual for wire feed
unit
- 7 -