Operation; Connections; Usb Connection - ESAB A2 PEK Instruction Manual

GB
5

OPERATION

General safety regulations for the handling of the equipment can be found on
page 4. Read through before you start using the equipment!
5.1

Connections

1 Emergency stop
2 Control panel, see separate instruction
manual
3 Connection (CAN) for remote control unit
or service tool
4 USB connection, see point 5.2
5 Connection for limit position switch or
cable with solenoid for gas
6 Connection of speed feedback for wire
feed
5.2

USB connection

The external USB memory can be used to transfer programs to and from systems.
During normal use there is no risk of "viruses" "infecting" equipment. To eliminate the
risk entirely, we recommend that the memory, which is used together with this
equipment, not be used for any other purpose other than its intended.
Certain USB memories may not work with this equipment. We recommend using
USB memories from a reputable supplier.
ESAB assumes no responsibility for any damage caused as a consequence of
incorrect use of the USB memory.
be01d1ea
7 Connection of speed feedback for travel
motion
8 Connection for arc voltage feedback
9 Connection of motor cable for travel
motion
10 Connection of motor cable for wire feed
11 Connection for control cable from power
source
- 8 -