Table of Contents
Advertisement
Explosion-Proof Housings and Mounts
Explosion-Proof Pan/Tilt Units
Type
FPHC..
Phoenix Explosion-Proof Aluminium Camera Housing and PTZ Head
Assemblies ATEX Certified for IIC Applications
The "Phoenix Explosion-Proof" equipment is ATEX-certified to be used
in potentially hazardous areas where there is a risk of explosion
because flammable gases‚ vapours‚ mists or dusts may be present. The
camera head‚ which comprises both a housing and pre-set pan-tilt head‚
is designed to prevent explosion by containing any heat‚ sparks‚ or
flames generated by equipment inside it. This prevents ignition of
potentially explosive atmospheres or materials outside the equipment.
The camera head is ATEX-certified for use in IIC gas environments
(includes hydrogen and acetylene). The housing is supplied complete
with heater & sun shield. The housing can have a wiper and integral 10
or 17fn AC Telemetry Receiver factory fitted.
Siemens will deliver this housing and PTZ head only as a factory pre-
built version with Siemens or customer-supplied camera and lens.
Therefore one of the Phoenix-FIT options must be ordered.
Please note‚ that Siemens cannot supply ATEX IIC Equipment certifi-
cates unless one of the Phoenix-CERT option is ordered with each
housing.
Glands are supplied for both ends of P&T lead. Suitable ATEX approved
cable glands for all other cables must be purchased separately.
Dimensions (W x H x D)
Colour
Cable entry
Pan speed
Tilt speed
Rotation
Finish
Load rating
Presets
Protection rating
Weight
FPHC-40
Phoenix 230 V AC ATEX IIC Explosion-Proof Preset Camera Head
As FPHC.. for technical details‚ but with the following differences:
Power requirements
Power consumption
© Siemens Building Technologies Group
Housing: 209 x 186 x 675 mm
P&T: 167 x 291 x 471 mm
Body: Polyester Powder Coat
RAL1021(Yellow).
Endplates: Clear Anodised.
Sunshield: White Polyester Powder
Coat.
Internal Terminal Block‚ 4 off 20 mm
x 1.5 threaded holes for certified
glands‚ fitted with BASEEFA certi-
fied blanking plugs.
4.5°/sec
Torque 45 Nm
Backlash ±0.15° (max.)
e.5°/sec
Torque 45 Nm
Backlash ±0.15° (max.)
Pan 252° (max.)
Tilt ±172°
Aluminium extrusion (housing
body)‚ aluminium (P&T body‚ all end
caps and housing sunshield)
40 kg
Standard
IP67 BS EN 60 529
Housing: 11.8 kg
P&T: 19.0 kg
230 V AC
51 VA
Order No.
FPHC..
S24245-C4070-A1
6
6-7
Advertisement
Table of Contents
