Assembly Of Workhorse Trap Onto Wobble Bird Base With Tripod Stand - Champion WOBBLE BIRD Owner's Instruction Manual

Assembly of Workhorse Trap onto Wobble Bird Base
with included Tripod Stand
1. Before installing a trap on the Wobble Bird Base, safely conduct a safe release on the trap and then safely remove the
mainspring. Refer to your trap's manual regarding the proper procedure for safe release and removal of mainspring.
If you are no longer in possession of the trap manual, do not continue assembly or use of the unit and contact
Champion customer service at (800) 379-1732 or look for a link to the manual on the web page for your trap at:
www.championtarget.com.
2. Several components on the Workhorse Trap will need to be removed from the trap.
a. To disassemble the trap, remove both Wire Lock Pins (F4).
b. Using a 10mm wrench, remove both Arm Path Tube Studs (F3). The Rear Leg (F6) can now be removed from
the trap.
c. Re-install both Arm Path Tube Studs (F3) using a 10mm wrench.
d. Using a 13mm wrench, remove both Front Legs (F5).
F3
F4
3. The following hardware configuration (below) shall be used when installing a WORKHORSE TRAP to the Wobble
Bird Base. Installation steps are shown in detail on the following pages. If you will be installing a WHEELYBIRD, see
page 13 for proper hardware assembly.
7
6
F6
14 16
11 13
F1
F5
16
12
9
13
6
14
7
10 6