Siemens SIMATIC NET CP 243-2 Manual page 136

AS-Interface Protocol Implementation
Table A-2 , continued
No. Function or Call on the Host Interface
(symbolic representation)
10 Status = Store_Actual_Configuration()
11 Status, Config =
Read_Actual_Configuration(Addr)
12 Status = Set_LPS(List31)
13 Status, List31 = Get_LPS()
14 Status, List31 = Get_LAS()
15 Status, List32 = Get_LDS()
16.0 Status = Get_Flags()
16.1 Status, Flag = Get_Flag_Config_OK()
16.2 Status, Flag = Get_Flag_LDS.0()
16.3 Status, Flag =
Get_Flag_Auto_Address_Assign()
16.4 Status, Flag =
Get_Flag_Auto_Prog_Available()
16.5 Status, Flag =
Get_Flag_Configuration_Active()
16.6 Status, Flag =
Get_Flag_Normal_Operation_Active()
16.7 Status, Flag = Get_Flag_APF()
16.8 Status, Flag = Get_Flag_Offline_Ready()
17 Status = Set_Operation_Mode(Mode)
18 Status = Set_Offline_Mode(Mode)
19 Status = Activate_Data_Exchange(Mode)
A-2
M1 Comment / Function implemented by /
Section
X By pressing the SET button; or with the
command
Store_actual_configuration
see Section 5.2.4
X Get_Extended_Actual_Configuration / see
Section 5.2.9
X Set_LPS / see Section 5.2.10
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X Get_LPS, Get_LAS, Get_LDS, Get_Flags
/
see Section 5.2.16
X By pressing the SET button; or with the
command
Set_operation_mode
see Section 5.2.13
X see Section 5.2.11
– not implemented
SIMATIC NET CP 243-2 AS-i Master
C79000-G8976-C142/02