Table of Contents
Advertisement
MACRO DEFINITIONS FORM
Table F–1 is a worksheet for planning macro buffer requirements. The labels at
the top match the macro definitions with the particular network and adapter.
They are:
Network
Enter the name used to describe the network with this
Name
adapter.
Location
Enter the location of the network and/or the adapter. This could be
the department in a plant, a plant, or any other definition.
UNILINK
The address or other identifier that specifies this adapter.
Host
Adapter
The form columns are
Macro
Enter the buffer number returned by the ALLOCATE
Buffer
MACRO STORAGE BUFFERS command which numbers
Number
the buffers sequentially beginning with 01 hex.
Command
Enter the length in bytes for the macro command buffer.
Buffer
Length
Response
Enter the length in bytes for the macro response buffer.
Buffer
Length
Source Id
Enter the Source Id associated with this macro.
Secondary
Enter the secondary device address associated with this
Address
macro.
Macro
Enter the type code for this macro:
Type
01 = Send Primitive
02 = Connect Secondary Device
03 = Disconnect Secondary Device
Primitive
Enter the primitive code from the secondary device manual or the
TIWAY I Systems Manual.
Auto
Check this box if the macro should be automatically
Enable
enabled.
Rept.
Check this box if the macro is to be a repetitive macro.
F–1
APPENDIX F
UNILINK HOST ADAPTER
USER MANUAL
Advertisement
Table of Contents
