Siemens SIMOTICS DC 1GH5 Operating And Installation Instructions page 27

● When lifting the machine, refer to the information on the lifting plate.
● Use only the load carrying device on the stator frame for lifting.
The machine can tip over, slip or fall down during transport if a different construction is used
If you do not transport or lift the machine in a position appropriate for its construction, the
machine can tip, slip into the lifting equipment or fall down. This can result in death, serious
injury or material damage.
● Use only the load carrying device on the stator frame for lifting.
● Use the load carrying device appropriate for the machine position.
● Use suitable rope guiding or spreading devices. The weight of the machine is shown on
The machine can fall over, shift or fall down during transport if the center of gravity is not
symmetrical
If the center of gravity of a load is not located centrally between the attachment points, the
motor can tip over or slip out of the lifting equipment and fall when it is being transported or
lifted. This can result in death, serious injury or material damage.
● Comply with the handling instructions on the machine when transporting it.
● Be aware of the possibility of different loads on the sling ropes or lifting straps and the
● Always take account of the center of gravity when transporting or lifting the motor. If the
SIMOTICS DC 1GH5
Operating Instructions 02/2016
– Comply with the specified spreading angles.
– Do not exceed the maximum lifting acceleration and lifting speed specified on the lifting
plate. Lift the machine without jerking it.
Acceleration a ≤ 0.4 g (≈ 4 m/s
Velocity v ≤ 20 m/min
WARNING
the rating plate.
WARNING
carrying capacity of the lifting equipment.
center of gravity is not located centrally between the attachment points, then position the
hoisting hook above the center of gravity.
)
2
Preparations for use
4.7 Transport and storage
27