Removing Rolling-Contact Bearings; Installing The Machine - Siemens SIMOTICS DC 1GH5 Operating And Installation Instructions

5. Before pulling off any parts that have been screwed on, replace two of the fixing screws at
6. Use forcing-off bolts or suitable devices to disassemble parts and components attached to
9.2.3

Removing rolling-contact bearings

● When removing rolling-contact bearings, ensure the parts are correctly allocated if they are
● Label the components as they are removed so that they can be correctly allocated during
9.2.4

Installing the machine

● If possible, assemble the motor on an aligning plate. This ensures that the brush rocker is
● When mounting the DE bearing shield, ensure that the windings that project from the stator
Sealing the motor
● Clean bare joints between parts, e.g. between enclosures, end shields and the active parts
● Grease the uncoated joints.
● For more stringent degree of protection requirements, a joint sealant is often used. In this
● Check the installed sealing elements. If the sealing elements do not seal sufficiently,
Bolt locking elements
● Refit nuts or bolts that are mounted together with locking, resilient, and/or force-distributing
● Always replace keyed safety elements.
● Always mount the fixing screws with a clamping length < 25 mm during assembly using
SIMOTICS DC 1GH5
Operating Instructions 02/2016
the top with excessively long screws or threaded bolts. This ensures that the part is
supported after it is pulled off.
the motor shaft.
the same size at the drive end and non-drive end. This affects the bearings, compression
springs, equalizing rings, and covers with different centering lengths.
assembly.
positioned correctly relative to the stator frame and the footings lie on a plane.
housing do not become damaged.
of bearings.
case, also seal the joints with a suitable silicone-free, non-setting sealing compound during
assembly. Use the sealing compound when inserting the relevant fixing screws.
replace them.
elements with identical, fully-functional elements when re-assembling. The force
distributing element include, for example, lock washers, split rings, etc.
suitable locking elements or a soluble threadlocker. For example, use split rings, spring
washers, or LOCTITE. The clamping length is taken as the distance between the head of
the bolt and the point at which the bolt is screwed in.
Maintenance
9.2 Repair
91