Powering The Accessory - Lionel Oil Tank Owner's Manual

Powering the accessory

T
his accessory operates best at 12-18 volts (AC). You may choose to power the accessory with
a separate accessory power supply, through a FasTrack Accessory Power Wire (6-12053), or
through a Lionel Lockon for O gauge track. To make the proper connections, all wires must be
stripped back 1/8" to 1/4".
Only an adult should perform this task. Always use care when stripping wires.
Caution!
Use a sharp knife or a pair of wire strippers.
To make the spring clip connections on the bottom of the accessory, press down on the top portion of
the spring clip so that a metal loop is exposed. Slide the bare end of the wire into the loop, and then
release pressure on the spring clip.
1. As illustrated in Figure 2, attach one wire to an accessory terminal and connect it directly
to your power supply, a FasTrack track section, or a Lionel Lockon.
To make the FasTrack track connection, purchase a FasTrack Accessory Power Wire
Note!
(6-12053) and connect it to the tabs on the underside of the track. Twist or solder
the bare end of the FasTrack wires with the wires that are attached to the accessory.
Wrap the connections with electrical tape.
2. Attach an additional wire to the remaining accessory terminal and connect it to a screw
terminal on the switch.
To make this connection, simply loosen the screw, bend the wire around the screw
Note!
post, and retighten the screw.
3. Attach a final wire to the remaining switch terminal and connect it to the remaining power
supply terminal, FasTrack Accessory Power Wire, or Lockon terminal.
POWER POWER POWER
SUPPLY SUPPLY SUPPLY
Figure 2. Power connections
U
OR
Lionel Lockon
Wire plug from oil tank
A
U
A
5
OR
FasTrack Accessory
Power Wire