Lionel O-27 Owner's Manual
Pennsylvania flyer ready-to-run
Hide thumbs
Also See for O-27:
- How to use manual (36 pages) ,
- Owner's manual (20 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
73-1951-250
Featuring
6/02
Two Exclusive
Bloomingdale's
Boxcars!
Lionel
Pennsylvania Flyer
Ready-to-Run O-27 Set
Owner's Manual
CAUTI O N—ELECTRI C TOY
NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITH
ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING
HANDLI N G AND USE TO REDUCE THE RI S K OF ELECTRI C SHOCK.
TRANSFORMER RATINGS—I N PUT:120 VAC; 60 HZ ONLY.
AC OUTPUT:20 V; 54 VA
Advertisement
Table of Contents
Related Manuals for Lionel O-27
Summary of Contents for Lionel O-27
- Page 1 Two Exclusive Bloomingdale’s Boxcars! Lionel Pennsylvania Flyer Ready-to-Run O-27 Set Owner’s Manual CAUTI O N—ELECTRI C TOY NOT RECOMMENDED FOR CHILDREN UNDER EIGHT YEARS OF AGE. AS WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLI N G AND USE TO REDUCE THE RI S K OF ELECTRI C SHOCK.
- Page 2 In the event that such conditions exist, the transformer should not be used until properly repaired. The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ®...
-
Page 3: Table Of Contents
Controller operations Stripping the wire Attaching the controller wires to the Lock-On Controller functions Controller and short circuits Train operation Running your locomotive with a Lionel transformer Reverse unit procedure Tire-Traction Coupling Maintaining and servicing your set Lubricating your 4-4-2 locomotive Adding smoke fluid to your 4-4-2 locomotive’s smoke generator... -
Page 4: Track Layout Joining The Track Sections
If any pins fall out of the track and are missing, replace them with extras available from your Lionel dealer. Maintenance tip: The rails should be kept clean, dry, and free from oil and grease. -
Page 5: Suggested Track Layouts
Track layout Suggested track layouts igure 2 provides some examples of lay- We recommend that you do not set Note! outs you can build with eight straight up your track layout on carpeted and eight curved sections of track. surfaces. Carpet fibers may collect on your Remember—the more track you own, the engine’s wheels and drive gears, preventing more variations you can create in your train... -
Page 6: Attaching The Lock-On To The Track
Track layout Attaching the Lock-On to the track he Lock-On connects power from your rail. The Lock-On should face outward when controller to the track. As illustrated in setting up your track. Make sure it is firmly Figure 3, attaching the Lock-On to the track connected. -
Page 7: Controller Operations
Controller operations Stripping the wire nce your track is assembled and the Only an adult should perform Caution! Lock-On is securely attached, you can this task! Always use care connect the wires from the controller to the when stripping wires. Lock-On. -
Page 8: Attaching The Controller Wires To The Lock-On
Controller operations Attaching the controller wires to the Lock-On ow you’ll need to insert a controller troller, and plug the other end into a stan- wire into each of the two spring clips on dard outlet. the Lock-On as illustrated in Figure 5. If the whistle fails to operate when Note! Depress the spring clip with your finger... -
Page 9: Controller Functions
Controller operations Controller functions s you turn the throttle control knob to pull, for example), the farther into the the right, power to the track is green the knob must be turned before it will increased. Refer to Figure 6 for the location operate the locomotive. -
Page 10: Controller And Short Circuits
Controller operations Controller and short circuits our Lionel power pack is listed by cause of short circuits, so make sure that all Underwriters Laboratories Inc. and has wheels are properly set on the rails. Some been carefully designed and tested to ensure other causes of short circuits might be sta- peak performance. -
Page 11: Train Operation
Train operation Running your locomotive with a Lionel transformer Place your locomotive on Lionel or Lionel-compatible track. (O-27 minimum radius) • With track power OFF, connect the drawbar between the locomotive and tender. See Figure 7. Caution! Add smoke fluid to your locomotive’s stack to prevent damage to the smoke unit. -
Page 12: Reverse Unit Procedure
Reverse unit procedure he electronic reverse unit inside your will be locked in the next mode of operation Lionel locomotive acts like the transmis- in the sequence. For instance, if the locomo- sion in your car. When you apply power to... -
Page 13: Tire-Traction
Traction at higher speeds. Replacement Traction Tires Tire to enhance tractive effort so your loco- are available at your authorized Lionel Service motive can pull many cars at once. Center. Coupling... -
Page 14: Maintaining And Servicing Your Set
When smoke production wanes, add more The smoke generator requires the periodic fluid (4 to 8 drops). An idle locomotive will addition of Lionel smoke fluid in order to not smoke. function. Pierce the smoke fluid tube end Smoke production is greater at higher volt-... -
Page 15: Replacing Your 4-4-2 Locomotive's Headlamp
Lionel part no. 600-0161-300, screws. Tighten the screws firmly, but do available from your nearest Lionel not over tighten them. Authorized Service Center or from Lionel Smoke unit Lionel part no. 600-0161-300 Linkage rods... -
Page 16: Limited Warranty/Lionel Service
Center, together with proof of original purchase above instructions carefully before returning any will, at the option of Lionel L.L.C., be repaired or merchandise for service. You may choose to have replaced, without charge for parts or labor. In the...
Need help?
Do you have a question about the O-27 and is the answer not in the manual?
Questions and answers