Oki PT340 Online Manual page 29

 SNMP
The following are the settings required to control this printer via the network (the settings can be entered
online or from SNMP).
Item
Authentic
Community
Trap
Community
Trap
Address(IP)
SNMP
SysContact
SysName
SysLocation Define "SysLocation" (up to 255 characters can be
Enable
AuthenTrap
*This printer supports the following types of traps:
・coldStart (a trap that will be issued upon power on)
・authenticationFailure (a trap that will be issued in the event of certification error)
・enterpriseSpecific (a trap that will be issued in the event of a printing error)
*For any trap issued from this printer to be received by an SNMP manager, both the printer and the
SNMP manager must exist in the same "Community" (= administration group).
If the Community value is blank or does not match, the SNMP manager cannot receive this printer's
trap.
*For security considerations, changing the default "public" settings is recommended.
Copyright (C) 2013 Oki Data Corporation
Settings details
Define "Authentic Community" for SNMP (up to 15
characters can be used).
The Authentic Community value is required for
certification to accept an SNMP Request.
Note) Blank spaces, 0x27 ( ' ) and 0x5C ( \ ) will not be
accepted.
Define "Trap Community" for SNMP (up to 15 characters
can be used).
The Trap Community value is required when this printer
issues a trap.
Note) Blank spaces, 0x20 ( ) and 0x09 ( \t ) will not be
accepted.
This is the destination IP address for SNMP traps.
Enter decimal values in a "xxx．xxx．xxx．xxx" format.
Setting this parameter to "0．0．0．0" will disable the trap
feature, with no traps being issued regardless of the
situation.
Define "SysContact" (up to 255 characters can be used).
"SysContact" is normally set to the administrator's e-mail
address.
Define "SysName" (up to 255 characters can be used).
"SysName" is normally set to this printer's Host or
Domain.
used).
"SysLocation" is normally set to this printer's location.
Enable (1) or disable (2) "Enable AuthenTrap".
When this parameter is set to "Enable (1)", an SNMP
trap will be sent to the destination IP address defined in
"Trap Address (IP)" in the event of an SNMP community
violation.
Printer LAN Online Manual 1.1.0.0
Factory
default setting
public
public
0．0．0．0
None
None
None
Disable（2）
28 of 34