Table of Contents
Advertisement
2
Scope Features and Functions
58
Automatic Measurement Procedures
Automatic measurements can be used on any channel source or
any running math function. Cursors are turned on to focus on
the most recently selected measurement.
1 Select the markers for your measurement.
Markers enable you to expand the time base around the start
and stop events of the time interval to be measured, thus
achieving more time resolution than the automatic
measurements.
2 Select either Channel 1 or Channel 2 according to the
waveform you want to measure. Math function and FFT
channel can be selected if they are enabled.
3 Select the desired measurement from the Measurements
panel. The Measurements Results panel is displayed at
bottom of the graph.
To select single or multiple measurements,
1 Drag and drop a measurement
Click on the desired measurement icon, while holding the
selected measurement, drag it over to the Measurements
Results panel. Drop the selection on the panel.
2 Drag and drop multiple measurements
On the Measurements panel, hold down the mouse button,
drag and select multiple measurements. Drag all the selected
measurements and drop the selections on the Measurement
Results panel.
3 Double- click on a measurement
Go to your desired measurement and double click on the
icon.
4 Select the measurement and press Enter
Click on the desired measurement icon and press Enter. To
select more than one measurement, press Ctrl and click on
the desired measurements icons then press Enter.
U2701A/U2702A Modular Oscilloscopes User's Guide
Advertisement
Table of Contents
